Weekly OSHA Site Safety Log


    Date

    Project Address:




    Sub-Contractor Email

    Safety Compliance Areas

    1. HOUSEKEEPING
    - General neatness of work area?
    - Projecting nails removed or bent over?
    - Waste containers provided and used?
    - Are passageways and walkways clear?

    In Compliance:

    Comments:

    2. FIRE PREVENTION
    - Adequate fire extinguishers, checked and accessible?
    - Phone no. of fire department posted?
    - “No Smoking” posted and enforced near flammables?

    In Compliance:

    Comments:

    3. ELECTRICAL
    - Extension cords or attachment cords with bare wires or missing ground prongs or damaged taken out of service?
    - Ground fault circuit interrupters being used?
    - Terminal boxes equipped with required covers?
    - Are flexible cords and cables protected from damage?
    - Are unused openings in cabinet boxes and fittings closed?
    - Are all cabinets, panels, and switches located in wet locations enclosed in weatherproof enclosures?
    In Compliance:
    Comments

    4. HAND, POWER & POWDER ACTUATED TOOLS

    - Hand tools inspected regularly? Broken handles and mushroom heads?
    - Guards in place on machines, such as saws?
    - Right tool being used for job at hand?
    - Operators of powder actuated tools are licensed?

    In Compliance:
    Comments

    5. FALL PROTECTION
    - Safety rails and cables are secured properly?
    - Employees exposed to fall hazards are tied off?
    - Employees below protected from falling objects?
    - Employees using body belts for positioning devices only?
    - Are employees working more than 6' above a lower level protected by guardrails, safety nets, personal fall arrest system?

    In Compliance:
    Comments

    6. LADDERS
    - Ladders extend at least 36" above the landing?
    - Ladders are secured to prevent slipping, sliding, or falling?
    - Ladders with split or missing rungs taken out of service?
    - Stepladders used in a fully open position?
    - No step at top two rungs of stepladder?
    In Compliance:
    Comments

    7. SCAFFOLDING
    - All scaffolding inspected daily?
    - Erected on sound rigid footing?
    - Tied to structure as required?
    - Guardrails, intermediate rails, toe boards and screens in place?
    - Planking is sound and sturdy?
    - Proper access provided?
    - Employees below protected from falling objects?

    In Compliance:
    Comments

    8. FLOOR & WALL OPENINGS
    - All floor or deck openings are planked over or barricaded?
    - Perimeter protection is in place?
    - Deck planks are secured?
    - Materials are stored away from edge?
    In Compliance:
    Comments

    9. TRENCHES, EXCAVATION & SHORING
    - Competent person on hand inspecting daily
    - Excavations over 5' in depth are shored or sloped back?
    - Materials are stored at least two feet from trench?
    - Equipment is a safe distance from edge of trench or excavation?
    - Ladders provided every 25' in trench more than 4' deep?
    - Have underground utility installations been located?
    - Are employees exposed to vehicular traffic wearing warning vests of reflective or highly visibility material?

    In Compliance:
    Comments

    10. PERSONAL PROTECTIVE EQUIPMENT
    - Hard hats are being worn?
    - Safety glasses are being worn?
    - Respirators are used when required?
    - Hearing protection being worn when required?
    - Traffic vests being worn?

    In Compliance:
    Comments

    OTHER UNSAFE PRACTICES OBSERVED

    Upload Photos
    Main Photo:

    Other Photos:
    [multifile multifile-704 limit:10000000000000000000000000000000000]

    Inspected by:

    Remediation Due by: